Sundance Spas 680 Manuel d'utilisateur télécharger pdf (Page 30)

Page 26

for a change when you cannot control sudsing and/or you can no longer

get the normal feel or sparkle to the water even though the key water

balance measurements are all within the proper parameters.

WARNING! READ THIS BEFORE DRAINING: To prevent

damage to the spa’s components, turn off power to the spa

at the circuit breaker before draining it. Do not turn the

power back on until your spa has been refilled.

CAUTION: There are certain precautions to keep in mind

when draining your spa. If it is extremely cold, and the spa is

outdoors, freezing could occur in the lines or the equipment

(see “WINTERIZING”, page 28. On the other hand, if it is hot

outdoors, do not leave the spa’s surface exposed to direct

sunlight.

To drain your spa, perform the following steps:

1. Turn off power to spa at breaker.

2. Locate and remove the synthetic cabinet door screws and door.

The door is located directly below the control panel and is easily

identified by it’s vertical cooling slots.

3. Pull drain hose from equipment area

(Figure-A)

4. Hold drain hose above water line, then

unthread drain cap from hose using a

counterclockwise rotation. Place drain

hose on ground to start drain making

sure to direct water away from spa

(Figure-B).

5. After spa has completely drained,

reinstall drain cap on drain hose fitting

by turning it clockwise until finger

tight! DO NOT OVERTIGHTEN!

6. Coil drain hose up and place back inside

the spa equipment bay (Figure-A).

7. Reinstall synthetic cabinet door and

screws.

8. After refilling spa, turn on power and

follow the “Spa Fill Up Procedure” listed on page 14.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 43 44

Pas de commentaire

Sundance Spas 680 Manuel d'utilisateur Page 30